Metrodata FM4900, Руководство пользователя

Страница: 28 / 68

INSTALLING & SETTING-UP
76-02-011F 20
The current value of that option will then be shown. Each time you press the space bar, the
next value will be displayed, cycling through the available values. When the required value
is displayed, simply press the <enter> key to accept the value or press <escape> to cancel
your choice. This process is known as toggling.
5 . 3. 2 VT100/VT220 and ANSI terminals
The displays you see on a VT100/VT220 or an ANSI terminal are very similar, and examples
are shown below:
Figure 5. 5 VT/ANSI Main set-up menu
When you press a letter which leads to a further menu, the screen will be refreshed without
scrolling, displaying the new menu.
The highlighted menu item REMOTE LOGON only appears on the screen when G.751
Framed mode is selected and DATALINK is enabled. The item MANAGEMENT only
appears if the LM1100 SNMP Enabler has been fitted to the FM4900.
If you press a letter corresponding to a menu option, the value opposite that option will be
highlighted. You will also see the prompts at the bottom of the screen, similar to the TTY
display:
Figure 5. 6 Prompt screen
MAIN SET-UP
alarm eXtension <menu>
General set-up <menu>
WAN port set-up <menu>
DTE set-up <menu>
V.24 set-up <menu>
Remote logon <display>
Management <menu>
Testing <menu>
Special <menu>
Performance data <menu>
HIGHLIGHTED letter - select item
<escape> - exit menu
<space> - change value
<enter> - save new value
<escape> - exit without saving