METRObility Optical Systems R821-1S, Инструкция по установке и эксплуатации

Страница: 79 / 127

77
CLI Commands
All Disabled – ICMP message processing is disabled.
All Enabled – ICMP message processing is enabled.
Broadcast Disabled – the processing of only unicast
ICMP messages is enabled. The processing of ICMP
messages sent to IP multicast, IP subnet broadcast,
and IP limited broadcast addresses is disabled.
Example :
Console> show icmp
status: All Enabled
Console>
show ip
Description : Show the device’s IP address, corresponding network
mask, and the default gateway IP address.
Syntax : show ip
Display
Parameters
: IP Address – identifies the end-station IP address.
IP Mask – identifies the end-station prefix (network mask).
Default Gateway – identifies the default route gateway IP
address.
Example :
Console> show ip
IP Address: 192.168.1.100
IP Mask: 255.255.255.0
Default Gateway: 192.168.1.254
Console>
show
l2controlprotocol
Description : Show the disposition for Layer 2 protocols on one or more
ports.
Syntax : show l2controlprotocol <stp | rstp | mstp | lacp | marker | 802.1X |
bridge | garp | gvrp | gmrp | all> port <port number | all>
Parameters : 802.1X – IEEE 802.1X Port Authentication Protocol.
bridge – LAN Bridge Management Protocol.
garp – IEEE 802 Group Attribute Registration Protocol.
gmrp – IEEE 802 GARP Multicast Registration Protocol.
gvrp – IEEE 802 GARP VLAN Registration Protocol.
lacp – IEEE 802.3ad Link Aggregation Protocol.
marker – IEEE 802.3ad Marker Protocol.
mstp – IEEE 802.1 Multiple Spanning Tree Protocol.
rstp – IEEE 802.1 Rapid Spanning Tree Protocol.
stp – IEEE 802.1 Spanning Tree Protocol, including Rapid
and Multiple Spanning Tree Protocols.
port number – the actual port number.
all – all three ports.
Display
Parameters
: Discard – specified protocol is being discarded (filtered).
Forward – specified protocol is being forwarded, based on
forwarding rules and policies.