METRObility Optical Systems R821-1S, Инструкция по установке и эксплуатации

Страница: 63 / 127

61
CLI Commands
Parameters : IP address – IP address of the download host in dotted
decimal notation.
name of file – case-sensitive ASCII string (50 characters
max.) denoting the name of the download file.
Example :
Console> set download server 192.168.1.100 filename control.bin
server: 192.168.1.100
filename: control.bin
protocol: tftp
status: Previous Flash burn completed successfully
Console>
set dscp
Description : Enable or disable DSCP classification to determine traffic
prioritization and specify the policy model to use.
Syntax : set dscp <enable | disable> [model <TOS | SP | EF | AF| FF>]
Parameters : enable – enable DSCP classification.
disable – disable DSCP classification. (default)
model – set DSCP classification to one of the following
policy models:
TOS – RFC 791/795 Precedence
SP – Straight Precedence
EF – Expedited Forwarding (default)
AF – Assured Forwarding
FF – Free Form
If the model is not specified, the last configured
model will be used; the default is EF.
Example :
Console> set dscp enable model AF
Console>
set fpga
Description : Select the FPGA software to be used by the device.
Syntax : set fpga <image number>
Parameters : image number – 1 or 2.
Example : Console> set fpga 1
FPGA1 image (1.0.0) will not become active until next reset.
Console>
set freeform
Description : Customize the free form service class policy that maps a
specific binary bit value to one of the four priority queues.
Syntax : set freeform <802.1P 0bxxx | DSCP 0bxxxxxx> queue <0-3>
Parameters : 802.1P – a three-digit binary number.
DSCP – a six-digit binary number.
queue – The priority queue value. 0 is low, 3 is high.
Example :
Console> set freeform DSCP 000111 queue 3
Console>