A 1322 / A 1422
Safety and operational considerations
7
2.2 Standards applied
The instrument is manufactured and tested according to the following regulations, listed
below.
Electromagnetic compatibility (EMC)
EN 61326 -1
Electrical equipment for measurement, control and laboratory use
- EMC requirements - Part 1: General requirements
Safety (LVD)
EN 61010 -1
Safety requirements for electrical equipment for measurement,
control, and laboratory use
– Part 1: General requirements
EN 61010 -2 -030
Safety requirements for electrical equipment for measurement,
control and laboratory use
– Part 2-030: Particular requirements
for testing and measuring circuits
Application
A 1322 and A 1422
VDE 0701 - 0702
Prüfung nach Instandsetzung, Änderung elektrischer Geräte
– Wiederholungsprüfung elektrischer Geräte - Allgemeine
Anforderungen für die elektrische Sicherheit
IEE Code of Practice
Code of Practice for In-service Inspection and Testing of
Electrical Equipment
EN 50699
Recurrent Test of Electrical Equipment
EN 50678
General procedure for verifying the effectiveness of the
protective measures of electrical equipment after repair
A 1422
IEC/EN 60974 - 4
VDE 0544 - 4
Arc welding equipment - Part 4: Periodic inspection and
testing
Note about EN and IEC standards:
Text of this manual contains references to European standards. All standards of EN
6xxxx (e.g. EN 61010) series are equivalent to IEC standards with the same number
(e.g. IEC 61010) and differ only in amended parts required by European harmonization
procedure.
