Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
WMKA21005
IMPORTANT
Please read all of the instructions before installation
MA012138
Minimalist Shower Mixer
Square Plate
01-2138
Use of this product is recommended for domestic and commercial applications.
All pipework must be thoroughly flushed prior to the installation of the mixer.
Inline filter washers must be installed on both hot and cold supplies to prevent foreign particles
damaging the ceramic cartridge.
Do not remove the ceramic cartridge from the mixer when installing.
Methven recommends a licensed plumber carry out all installations in compliance with
the requirements of AS/NZS 3500. This product complies with AS/NZS 3718 regulations.
JULY 2012
Installation Guide
www.methven.com
Customer Care Hotline: 1300 METHVEN (638 483)
Email: [email protected]
Installation
1. Screw the body assembly (1) on to the
mounting stud positioned to observe
installation depth, ID (to front of finished
wall lining e.g. tiles) as follows:
Range of Install Depth,
ID
= 62 ± 12mm
2. Connect body assembly (1) into system
and replace body assembly cover.
3. Cut hole in lining as pictured.
4. Wall lining e.g. tiles should be finished as
close as possible to the plastic template.
Remove plastic template prior to next
step.
5. Lubricate the o-ring in the faceplate (2).
Place faceplate (2) over mixer body and
slide firmly over the mixer body until flat
on the wall surface. It is recommended
that a bead of silicone sealant is applied
to the back of the faceplate before fixing
to the finished wall surface.
6. Screw on half dome (3). Fit handle (7) and
fasten grub screw (6) with 2.5mm hex key.
Screw on lever (5) onto grub screw (6).
4.
6.
5.
ø 70mm Maximum for
Square Plate
1.
3.
2.
Plastic Tiling Template
ID
