18442-01
10.2021
AROYA SCALE CART INSTRUCTION SHEET
METER Group, Inc. USA
2365 NE Hopkins Court, Pullman, WA 99163
T
+1.509.332.5844
F
+1.509.332.5158
E
W
metergroup.com
Preparation
The AROYA H512 Scale Cart is designed to be used with the
AROYA H510 Portable Scale to hang and weigh individual plants.
Remove all contents from the box and confirm that the pieces
shown above have arrived intact. A 9/16-in wrench is needed to
assemble the cart.
Installation
1. With a 9/16-in wrench, loosen and remove the top nut,
washer, and bolt (A) at the base of the bottom neck (C).
2. Grasp the top neck handle (B) and lift the bottom neck (C),
top neck (E), and tabletop (F) up to an upright position.
F
B
C
D
A
3. Reinsert the bolt and washer (A) at the base of the bottom
neck (C).
4. Screw the nut onto the bolt (A) and hand tighten.
NOTE: Do not overtighten before raising the neck or the neck will not raise up easily.
C
A
5. Rotate the table top (F) over so it provides a flat surface for
the portable scale.
E
F
6. Remove the neck pins (D) located where the bottom neck
(C) and top neck (E) overlap and set aside.
F
E
D
C
Front view
E
C
D
7. Adjust the top neck (E) to the desired height by lifting up on
the top neck (E).
The top neck (E) fits and slides up and down inside the
bottom neck (C) to change the tabletop (F) height to a
maximum height of 5.5 ft.
8. With the top neck (E) holes aligned with the bottom neck (C)
holes at the desired height, insert the neck pins (D) to secure.
E
C
D
F
The scale cart is ready for the scale to be placed on the tabletop (F).
C—Bottom neck
E, F—Top neck, Tabletop
D—Bolt and pin (x4) G—Neck extension
A—Screws (x2)
nuts (x2)
washers (x4)
