Metek 920, Руководство оператора с основными требованиями по охране здоровья и безопасности

Страница: 136 / 278

4-28 | Model 920 Multi-Gas Analyzer
Configuring the Analyzer Control Functions
Output Signal Assignment (OSA)
Outputs (parameters) are calculated by the analyzer. Each result can be
one of two output types:
• Instantaneous
This output tracks the analyzer response during an Auto-Zero or
Auto-Span sequence.
• Track-and-Hold
This output records the concentration value that was calculated just
before an Auto-Zero/Auto-Span was initiated. It retains this value for
the duration of the Auto-Zero/Auto-Span and the Sample Delay Time.
The parameter can be assigned to any of the four output channels and,
optionally, the User Interface. The assignment is made by displaying the
output number and assigning it a numeric code (Figure 4-4).
An undefined result code will default to a primary code, using the
last digit that was entered. For example, a code of 83 will default to a
primary code of 3.
Figure 4-4.
Calculated Result
(Parameter) Codes.
Definition
CODES
User Interface and Analog Output Analog Output Only
Instantaneous
Result
Instantaneous O
2
Corrected Output
T&H
Result
T&H O
2
Corrected Output
Instantaneous
Result T&H
T&H O
2
Corrected
Output Not Used 0 0 0 0 0 0 0
Result 1 (low range SO
2
concentration in SO
2
/ NO
x
application)
1 21 51 71 101 151 171
Result 2 (NO
2
concentration
in SO
2
/ NO
x
application)
2 22 52 72 102 152 172
Result 3 (NO concentration in
SO
2
/ NO
x
application)
3 23 53 73 103 153 173
Result 4 (dual range SO
2
concentration in SO
2
/ NO
x
application)
4 24 54 74 104 154 174
Result 5 (reserved) 5 25 55 75 105 155 175
Result 6 (Neutral Drift) 6 26 56 76 106 156 176
Result 7: sum of Result 2 and
Result 3 (NO
x
in SO
2
/ NO
x
application)
7 27 57 77 107 157 177
Reserved
8 N/A N/A N/A N/A N/A N/A
Result 9 (O
2
output)
9 N/A 59 79 109 159 179

NOTE