MetalMaster Chassis system 3.0, Инструкция по эксплуатации

Страница: 59 / 60

Installing the Battery
Battery installation
IMPORTANT: Don´t mix up the poles!
1. Push the spring-contact with the lover edge of the
Battery-end (negative pole) into the spring housing.
Do not try to push with the center of the Battery-
end. It would not work that way.
Then tilt the other end with the positive pole.
2. When the battery is horizontal, push it in to the
final position.
Installing the Battery cover Part 07
Place the battery cover Part07 over the
battery and install the two steel rods.
Make sure the rods have the correct
length.
For removing the battery you have to
remove the two rods again.
Push the rods out. Use pliers. Then pull
them from the back.
Remove the cover.
59