Metabo HPT SB 3608DA, Инструкции по безопасности и руководство пользователя, Страница: 13 / 72

13
English
ASSEMBLY AND OPERATION
APPLICATIONS
○ Sanding fi nish and fl ooring fi nish of woodwork
products.
○ Base polishing of Lumber-coated planes.
○ Sanding fi nishes of metal surfaces.
○ Base polishing of metal-coated planes, rust removal,
or paint removal paint to re fi nishing.
○ Surfacial fi nish of slate, concrete, and so on.
INSTALLING AND REMOVING THE
BATTERY
WARNING
Check to con fi rm that the switch is turned o ff
before inserting the battery into the tool.
Inserting the battery with the switch turned on may
cause the tool to malfunction.
○ How to install the battery.
Align the battery with the groove in tool and slip it into
place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 6).
○ How to remove the battery.
Withdraw battery from the tool while pressing the
latch (2 pcs) of the battery (Fig. 6).
Latch
Battery
Pull out
Push
Latch
Fig. 6
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on
the nameplate, the charger will burn out.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charge
indicator lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in Fig. 7.
Battery
Guide rail
Pilot lamp
Fig. 7
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1- second intervals.) (See
Table 2)
(1) Lamp indication
The indications of the pilot lamp will be as shown
in Table 2, according to the condition of the battery
charger or the battery.
00Book̲SB3608DA̲metabo.indb 13 00Book̲SB3608DA̲metabo.indb 13 2022/08/02 23:45:55 2022/08/02 23:45:55