Intercom
Operating Instructions
•
Charge the batteries before use if you have not used them for a longer period (self discharge of the NiMH
batteries) and after use.
•
To avoid capacity loss due to the memory effect, discharge the batteries completely every 5 charging cycles. To
do this, leave the device on, until it turns off by itself. Then start the charging process as described above.
§
Risk Through High Voltage at the Charging Device
•
The charger works with mains voltage.
•
Security references for work with mains voltage must be followed.
!
Warning of Reduced Capacity and Life Span of the Batteries due to Maloperation
Use only the intended chargers from mk messtechnik GmbH.
Powered devices must never be used with a connected charger, e.g. for buffering an empty
battery.
Disregard can lead to a loss of capacity and a shortened life span of the battery in a short time.
9.3 Charging the Batteries (Battery Pack or Integrated into the Device)
Start of the Charging Process
•
Place the battery pack or the device to charge onto a stable and skidproof surface.
•
Turn off the device (see appropriate chapter for operation and operating controls).
•
Connect the charger with the battery pack or the device using the designated screw connector (see
appropriate chapter for operating elements).
•
Plug the power cord of the charger into the power socket.
•
Do not power on the device during charging, this can damage the device.
•
Check the status of the charging LED periodically (the meaning of the states are printed onto the housing of the
charger).
End of the Charging Process, after the Charging LED Displays the Status “Full”
•
Make sure that the device to charge is still turned off.
•
Remove the connection between the charger and the screw connectors of the battery pack or the device to
charge.
•
Remove the power plug of the charger from the socket.
•
The device or battery pack is now ready for operation.
Page 18 / 23
Distributed by: Reliant EMC LLC, 3311 Lewis Ave, Signal Hill CA 90755, 4089165750, www.reliantemc.com