Adjust and operate the M=LIGHT LED
M=LIGHT Control
54
/
88
05.02.2019
8LE-D23_BA_E.docm
5.4.3 Configuring M=LIGHT LED for pulsed operation
In pulsed operation, there are two different operating modes:
I
Auto Flash Light
I
Flash Light
5.4.3.1
Auto-Flash Light
operating mode
Figure 45: Tab
Auto Flash Light
Designation
Description
Frame Rate:
Indicates the measured frequency of the selected M=LIGHT LED.
Exposure Time:
Indicates the measured pulse duration of the selected M=LIGHT LED.
Pulse delay [µs]
Indicates the pulse delay in µm.
Adjustable with slide control
or arrow keys
If
Pulse delay
is set to 0, the delay between Sync signal and flash is approx. 10 µs.
Power [%]
Indicates the intensity in % with which M=LIGHT LED is to be switched on as long as
the pulse is active.
Adjustable via slide control or arrow keys
.
Read:
Indicates the current setting of the selected M=LIGHT LED.
OFF:
Switches all connected M=LIGHT LEDs to power = 0%.
Send:
Transfer settings to M=LIGHT LED.
Flash Calculator:
Opens window for checking
Frame rate
and
Power rate
.
Invert Input:
Select input signal for the Sync.
Invert Input
NOT selected: rising edge of Sync signal.
Invert Input
selected: falling edge of Sync signal.
