- 93 -
U.motion KNX Server Plus, Touch
Installation Manual
In the expert mode, the additional settings are available:
VISIBLE
Sets the object visible in the VISUALISATION or not.
WRITE ACCESS ACTIVE
Enables the commanding of the object in the
VISUALISATION; if it is disabled it shows only the status of
the object.
ENABLE PIN CONTROL
NEW PIN
REPEAT NEW PIN
Whit this option the room can be PIN-protected. To enable
the PIN-protection the PIN has to be inserted into the field
“NEW PIN” and in “REPEAT NEW PIN”.
11.5
I
NTEGRATORS
The INTEGRATORS enable the calculation of the time integral of objects present in the U.motion KNX Server Plus Touch
database. For example it is possible to calculate for how long a certain light was in the status "ON"; the result of such an
INTEGRATOR would be the time period (in seconds) for which the light was powered on.
To create a new INTEGRATOR, simply open the ADMINISTRATION menu, select “ADVANCED FUNCTIONS"
→
"VIRTUAL
OBJECTS" and click on the ADD-button. The newly created INTEGRATOR provides the following options:
MEASURING UNIT
The measuring unit for the calculation (displayed also in the VISUALISATION) can be
entered here
ICON
The icon, which will represent the object inside the VISUALISATION, can be selected
here.
SCALE FACTOR
The value obtained from the object is multiplied by this factor. "1" should be entered
here if no scaling of the obtained value in the calculation of the integral is desired or
if you just want to obtain the time period (in seconds) as result of the integral.
Note
: When for the scale factor a decimal number is used, please use a dot as separa-
tor.
TYPE OF DATA
Defines if the result of the integral will be shown as numeric value with (“Real”) or
without (“Integer”) comma.
Once all settings have been made, the object, whose value should be used to calculate the time integral, must be speci-
fied. Simply open the search function, locate the desired object and pull it into the area "INPUT OBJECT OF THE INTE-
GRATOR" ("drag and drop").
Only one object can be inserted into the list "INPUT OBJECT OF THE INTEGRATOR", since each INTEGRATOR
can integrate only one value and not several values; if nevertheless is tried to add more objects into the area,
a corresponding error message will appear.
Not all objects can be used for the calculation of an integral; if not compatible objects are pulled into the area
"INPUT OBJECT OF THE INTEGRATOR", an error message will appear. For KNX objects it must be ensured that
they are enabled for operation (write permission).
As soon as an INTEGRATOR is completely configured, it can be used inside the VISUALISATION, where it will appear as
shown below:
