- 119 -
U.motion KNX Server Plus, Touch
Installation Manual
•
The base state of the object is not changed by the priority control, which helps avoiding
erroneous control (like unwanted activation) of the loads
•
LOAD AUTO/MAN If present, this object permits the user to independently define through the VISUALISATION whether
a load should be controlled by the load control (AUTOMATIC) or should permit only manual control;
in the second case, the load control logic will not turn off/on the load, which can be helpful if loads
should be temporarily excluded from the load control.
After making changes to the loads connected to a running load control, it is necessary that the load control is
restarted using the corresponding buttons in its properties window. Only in this way the changes will be taken
over.
13.4.4
R
EPRESENTATION IN THE
V
ISUALISATION
At completed configuration of a load control, the user can find it in the VISUALISATION in the section “LOADS” (by
selecting the entry “ENERGY” from the NAVIGATION MENU):
Selector Load control (if more than one present)
Energy counter
Loads
