merten MEG6260-0410, Руководство по установке

Страница: 10 / 127

- 10 -
U.motion KNX Server Plus, Touch
Installation Manual
1.3 I
NSTALLATION
, C
ONNECTION AND
C
OMMISSIONING
1.3.1 I
NSTALLATION AND
C
ONNECTION
U.motion KNX Server Plus Touch fits into the available mounting units. For a correct function, the following connections
must be guaranteed:
•
Power supply 230V AC
•
KNX bus connection via supplied connector
•
Network connection via CAT5 network cable
Hint : the connection to the KNX bus is not really needed for the configuration of U.motion KNX Server Plus
Touch, but it allows a more efficient programming, since direct tests on the system can be performed.
When commissioning U.motion KNX Server Plus Touch, the following steps must be followed:

Power off the system/installation

Mount U.motion KNX Server Plus Touch into the installed mounting unit

Connect power supply and KNX bus to U.motion KNX Server Plus Touch

Power on the system/installation

Wait until U.motion KNX Server Plus Touch has booted up
ATTENTION!
If the U.motion KNX Server Plus Touch hardware is changed, irreversible damage can occur. Any intervention on
the equipment should be performed only by authorized personnel.
1.3.2 E
NVIRONMENTAL
C
ONDITIONS
The correct function of U.motion KNX Server Plus Touch can be granted only if the following requests are met:
OPERATION Ambient temperature 0°C - 30°C
1.3.3 C
OMMISSIONING
U.motion KNX Server Plus Touch is power supplied by 230V AC.
1.4 N
ETWORK
C
ONNECTION
For the usage/configuration of U.motion KNX Server Plus Touch a working network connection is required. In order to
make the first access to U.motion KNX Server Plus Touch, or if a compatible network is not available, follow these steps:
•
Connect U.motion KNX Server Plus Touch through a crossed network cable (“crossover-cable”) with your PC
•
Open the network configuration of your PC
•
Change the settings of the TCP/IP – Protocol (Version 4) of the network interface, on which you connected the
network cable and enter the following values:
•
IP address: 192.168.0.100
•
Subnet mask: 255.255.255.0
•
Gateway: 192.168.0.110
•
Save the new settings; depending on the installed OS a restart can be necessary.
ATTENTION! Before commissioning U.motion KNX Server Plus Touch all connections must be checked!
Verify that the voltage of the connected power supply doesn’t exceed the supported voltage range, in order
to avoid damage on the device!