MERLO P25.6, Инструкция по эксплуатации

Страница: 169 / 232

M
M
3
3
-
-
Z
Z
M
M
2
2
-
-
0
0
3
3
(
(
E
E
N
N
)
)
1
FORKS SECTION 1 MODULE 3
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
WARNING!
RISK OF ACCIDENTS!
Space the forks evenly before handling a load.
DO NOT lift loads with only one fork.
DO NOT handle overhead loads with the
forks.
DO NOT install additional forks or other
attachments on the carriage at the same time as
the forks.
DO NOT request the help of another operator
for the hooking or locking of the forks.
Position the forks parallel on the ground.
Driving the machine close to the forks.
Engage the parking brake (37).
Position the gear selector (19) and the
direction selector (20) in neutral "N".
Rotate the carriage downwards.
Extend the boom almost as far as the
attachment's couplings.
Lift the boom and at the same time turn the
carriage upwards until the carriage hooks the
forks
Lift the forks a few centimetres off the ground.
Get down from the cab and close the cab door.
VISUALLY verify that the locking devices (B) of
the forks [Figure 4] are properly lowered to
prevent the possible accidental release of the
fork: otherwise, act on the locking device (B)
from the outside and move it manually to the
locking position.
WARNING!
RISK OF ACCIDENTS!
DO NOT use the forks if both locking devices (B)
are not fully lowered: otherwise, lower the
boom and repeat the hooking procedure.
Insert the supplied lateral locking devices (C) to
prevent the lateral sliding of the forks.