12
22
WIRELESS PROGRAMMING (REMOTE ACCESSORIES)
NOTE: The transmitters supplied with your opener are preprogrammed by the factory.
If you purchase additional transmitters, the garage door
opener must be programmed to accept the new
transmitter code.
Program the receiver to match additional transmitter
codes:
Using the “S” SAVE Button
1.Press and hold the button on the transmitter that you
wish to use (1).
2.Press and release the “S” button on the opener (2).
3.Release the transmitter button when the courtesy light
flashes twice. It has learnt the code. If you release the
transmitter button before the opener light flashes, the
opener has not learnt the code.
The opener will now operate when the transmitter button is pressed.
To Erase all Transmitter Codes
1.Press and hold the “S” button on the opener until the courtesy light flashes twice, and continue
holding for approximately 8 seconds, until the courtesy light flashes twice again.
2.Release the button, all codes are now erased.
Activate the opener only when door is in full view, free of obstruction and properly adjusted.
No one should enter or leave the garage while the door is in motion. Do not allow children to
operate push buttons or transmitters. Do not allow children to play near the door.