12
Cycle Time / Calibration
To adjust cycle time and calibration of the system, please contact Meritech customer service for
assistance.
Please refer to “Contacting Meritech” in this manual.
System Cleaning
Depending on the environment that the system is installed, the type or frequency of use, and/or the
types of soils being removed from the boots, will determine the frequency and the type of cleaning
the system should endure. The cleaning process should also be documented within your HAACP or
SSOP procedures and/
or per your company’s internal procedures.
Meritech recommends daily cleaning of the system, as well as the Boot Sanitizing Pan. Please refer to
the CleanTech Maintenance Manual or request the specific cleaning instructions from Meritech
customer service.
Boot Sanitizing Pan Cleaning Instructions:
1.
Carefully and slowly lift the Boot Sanitizing Pan to drain the water from the pan. See photo
below.
2.
Hold the pan up at a 30°angle for approximately 15 seconds.
3.
Once drained - pull pan forward and disconnect the supply line by pushing the silver button.
See photo below.
