Meridian DSP5000C, Руководство пользователя, Страница: 30 / 63

Customising using Config 30
DSP5000C User Guide
Customising using Type
Type is a mode used specifically to restore the entire memory (except the
calibration memory) of DSP5000C to one of eight factory-preset
configurations. For all eight Types, Type resets the following:
•
phase to positive
•
axis to –1
•
balance to central (L 0)
•
tilt to 0.0
•
bass to 0.0
•
centre position to 1
•
speaker to left master or centre master (Type 6)
Depending on the Type selected, the other options are set as follows.
More information is given in Appendix 1, on page 52.
Type Application D1 input
for
source
D2 input
for
source
1 500 mode, controller like 562 all na
2 208 mode, with other Meridian
equipment in the system CD others
3 201/601 mode, with other Meridian
equipment in the system all na
4 201/601 mode, with other Meridian
equipment in the system CD others
5 500 mode, CD direct CD others
6 500 mode, Meridian Digital Theatre all na
7 500 mode, Second room system all na
8 500 mode, Additional room system all na
When programming DSP5000C speakers, it is best to choose one of the
three standard Types as a starting point, and it may be possible to find
one that meets your needs exactly. Otherwise, choose the one that is
closest to your requirements. Select it, and set up the master/slave and
left/right speakers, by means of the following steps:
Selecting Types
1. Switch off the DSP5000C, using the power switch on the back, and
wait for 3 seconds
2. While pressing the 6 key (or 2 for Type 2, 5 for Type 5 etc.) on the
remote control, switch the power on again. The display will read
TY. #
where # is the Type you have selected.
3. Release the # key
After a couple of seconds, the display will change to
C.
This indicates that this speaker will be a centre master.