Mercury VesselView Mobile, Руководство пользователя

Страница: 67 / 115

Section 4 - Main Menu
90-8M0070299
eng
MAY 2012 Page 63
9. Press the down arrow on the arrow pad to proceed to the "TRANSITION SPD" option.
10. Transition speed is the boat speed at which VesselView stops looking at the paddle wheel and starts looking at the pitot
when equipped. The default setting is 25.0 MPH and can be set as low as 3.1 MPH. Press the left or right arrow on the
arrow pad to decrease or increase the transition speed.
11. Once you have finished adjusting your sensors, press the check button to save the session.
NOTE: After any change or customization to the VesselView configuration, a blue pop‑up message will appear as a reminder to
save the session. It is recommended that all session changes be saved before holding the "
X
" button while keying all engines
off. Refer to
Section 1
‑
Saving the Settings
.
Warnings
The "WARNINGS" screen enables you to turn the VesselView warning horn on or off and to adjust the fuel level alarm values.
The menu path is: "Main" > "Settings" > "Warnings." Press the check button to open the "WARNINGS" screen.
a - Warning horn
b - Fuel critical level
c - Fuel low level
1. Upon entering the "WARNINGS" screen, the "WARNING HORN" option will be highlighted in blue.
NOTE: The VesselView warning horn can be turned "ON" or "OFF." By selecting "OFF," all engine alarms will be heard
through the key switch harness warning horn. By selecting "ON," all alarms will be heard through the key switch harness
horn and the VesselView horn. For warning horn details, refer to
Alarms
.
2. Press the left or right arrow on the arrow pad to select either "ON" or "OFF."
3. Press the down arrow on the arrow pad to proceed to the "FUEL CRIT LEVEL" option.
4. The fuel critical level default setting is 10% and can be increased by pressing the right arrow on the arrow pad.
NOTE: The fuel critical level percentage cannot be set below 10%, or higher than the fuel low level percentage.
5. Press the down arrow on the arrow pad to proceed to the "FUEL LOW LEVEL" option.
6. The fuel low level default setting is 25% and can be increased by pressing the right arrow on the arrow pad. The highest
you may set the fuel low level is 50%.
NOTE: The fuel low level percentage cannot be set below the fuel critical level percentage.
7. Once you have finished adjusting your warnings, press the check button to save the session.
NOTE: After any change or customization to the VesselView configuration, a blue pop‑up message will appear as a reminder to
save the session. It is recommended that all session changes be saved before holding the "
X
" button while keying all engines
off. Refer to
Section 1
‑
Saving the Settings
.
a
b
c
27143