90-8M0118300 eng MARCH 2016
© 2016 Mercury Marine
Page 1 / 4
TRIM ROD ASSEMBLY KIT
L6 VERADO
IMPORTANT: This document is written to aid our dealers and company service personnel in the proper installation or service
of our products. Persons who are not familiar with these or similar products produced by Mercury Marine, and who have not
been trained in the recommended servicing or installation procedures should have the work performed by an authorized
Mercury Marine dealer. Improper installation or servicing of the Mercury product could result in damage to the product or
personal injury to the installer or persons operating the product. Always refer to the appropriate Mercury Marine service
manual for component removal and installation instructions.
NOTE: After completing installation, these instructions should be placed with the product for the owner’s future use.
Components Contained in Kit
6430
a
b
Ref. Qty.
Description
Part Number
a
1
Shock rod assembly
NSS
b
2
Trilobe pin
821539
Trim Cylinder Rod Kit Installation
Power Trim System Removed from Outboard
Installation
1. If the power trim system was removed from the outboard, refer to
Power Trim
‑
Trim Cylinder and Pivot Pin
in the
appropriate service manual for removal and installation instructions.
2. After installing the components, fill and bleed the power trim system. Refer to
Check Fluid and Purge the Power Trim
System
in the appropriate service manual.
Power Trim System Installed on Outboard
Removal
NOTE: If the power trim system is installed on the outboard, the trim cylinder rod assembly may be removed without removing
the complete power trim system from the outboard.
1. Engage the tilt lock. Refer to
Power Trim
‑
Power Trim System
in the appropriate service manual.
2. Remove the trim cylinder rod ends from the mount cradle. Refer to
Power Trim
‑
Power Trim System
in the appropriate
service manual.
