Mercury MerCruiser Axius SeaCore 350 MAG, Руководство пользователя

Страница: 98 / 170

Section 5 - Maintenance
Page 90 90-8M0050539
eng
MAY 2011
Sterndrive Gear Lube
Checking
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil, coolant,
or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing the disposal
or recycling of waste, and contain and dispose of fluids as required.
NOTE: The oil level fluctuates during operation, so check with the engine cold before starting.
1. Check the gear lube oi level. Keep the oil level within the recommended operating range.
2. Inspect the lubricant condition. If any water is visible at the bottom of the gear lube monitor, if water appears at the fill and
drain plug hole, or if the gear lube appears discolored, contact your authorized Mercury MerCruiser dealer immediately. These
conditions can indicate a water leak in the sterndrive.
43200
Gear lube monitor
Filling
New installations may require as much as 470 mL (16 fl oz) of gear lube added to the monitor bottle during the break‑in period
(20 hours of running time). It is important to monitor and maintain the gear lube level during the break‑in period.
IMPORTANT: The gear lube monitor must be checked and filled if necessary at the beginning of each day when the engine is
cold. If the gear lube alarm sounds during the day's activity, add the appropriate amount of gear lube to the monitor bottle.
NOTE: If filling the entire sterndrive, see
Changing
.
1. Remove the gear lube monitor cap.
2. Fill the monitor with the specified fluid until the gear lube level is in the operating range. Do not overfill.
Tube Ref No. Description Where Used Part No.
87
High Performance Gear
Lubricant
Gear lube monitor 92-858064K01
3. Replace the cap.
Changing
1. Remove the gear lube monitor from the bracket.
2. Empty the contents into a suitable container.
3. Install the gear lube monitor in the bracket.
4. Bravo One Models:
a. Remove the propeller.
b. Position the sterndrive unit to the full down position.
c. Remove the oil fill and drain screw and sealing washer.