Mercury MerCruiser Axius SeaCore 350 MAG, Руководство пользователя

Страница: 62 / 170

Section 3 - On the Water
Page 54 90-8M0050539
eng
MAY 2011
Starting the Engine After It Has Been Stopped While In Gear
IMPORTANT: Avoid stopping the engine if the sterndrive unit is in gear. If the engine does stop, refer to the following procedure:
1. Push and pull repeatedly on the remote control handle until handle returns to the neutral/idle position. This may take several
tries if the power package was operating above idle RPM when the engine stopped.
2. After the handle returns to the neutral/idle position, resume normal starting procedures.
Throttle‑Only Operation
1. Refer to
Remote Controls
section for remote control features.
2. Move the control lever to the idle/neutral position.
3. Depress and hold the throttle only button, and move the control lever to the idle/forward or idle/reverse position.
4. Advancing the control lever beyond the idle/forward or idle/reverse position will cause engine speed to increase.
IMPORTANT: Moving the control lever back to the idle/neutral position will disengage the throttle only button and allow the
engine to shift into gear.
5. Throttle only mode is deactivated by moving the control lever to the idle/neutral position. Moving the control lever from the
idle/neutral position to the idle/forward or idle/reverse position without pressing the throttle only button will shift the unit into
the chosen gear.
Trailering the Boat
Your boat can be trailered with the sterndrive unit in the up or down position. Adequate clearance is required between the road
and sterndrive when transporting.
If adequate road clearance is a problem, place the sterndrive unit in full trailer position and support it with an optional trailer kit
which is available from your authorized Mercury MerCruiser dealer.
Freezing Temperature Operation
IMPORTANT: If the boat is operated during periods of freezing temperature, precautions must be taken to prevent freeze damage
to the power package. Damage caused by freezing is not covered by Mercury MerCruiser Limited Warranty.
Drain Plug and Bilge Pump
The engine compartment in your boat is a natural place for water to collect. For this reason, boats are normally equipped with a
drain plug and/or a bilge pump. It is very important to check these items on a regular basis to ensure that the water level does not
come into contact with your power package. Components on your engine will be damaged if submerged. Damage caused by
submersion is not covered by the Mercury MerCruiser Limited Warranty.
Basic Boat Operation (DTS Models)
Launching and Boat Operation
IMPORTANT: Install bilge drain plug prior to launching boat.
Operation Chart
Operation Chart
BEFORE STARTING AFTER STARTING WHILE UNDERWAY AFTER STOPPING
Install bilge drain plug.
Observe all gauges to
check condition of engine.
If not normal, stop engine.
Observe all gauges to
check condition of
engine. If not normal,
stop engine.
Turn ignition key to the
"OFF" position.
Open engine hatch.
Check for fuel, oil, water,
fluid and exhaust leaks.
Listen for the audio
alarm.
Turn battery switch to the
"OFF" position.