Mercury MerCruiser Axius 350 MAG, Руководство пользователя

Страница: 145 / 151

Section 7 - Troubleshooting
90-864197084 NOVEMBER 2008 Page 137
Symptom Remedy
The ERC lever controls the engine and drive, but does
not reach wide open throttle.
If the engine only reaches 50% of WOT, check the "DOCKING" button
on the DTS trackpad. Put the handles in neutral and push the button
to disengage, if light is on.
Check VesselView to see if cruise control enabled. Disable cruise
control.
Check for damage to the propeller. Check VesselView for Guardian
fault codes that indicate reduced engine power. If found, contact your
authorized Mercury MerCruiser dealer to ask if the propellers need to
be changed.
The ERC lever controls the engine and drive, but does
not respond in a linear manner.
Check the "TROLL" button on the DTS track pad. Put the handles in
Neutral and push the "TROLL" button to disengage, if light is on.
Check whether dock mode or cruise control are on. If on, turn off or
disengage.
When one ERC lever is moved, both engines respond.
Check the "1 LEVER" button on the DTS track pad. If the light is on,
put the handles in neutral and push the "1 LEVER" button to
disengage.
The ERC control, joystick, and steering wheel do not
function.
Press "HELM" on DTS track pad to restore helm control. (Multiple
helm boats only.)
Steering System
Symptom Remedy
The steering wheel steers the boat, but operates without
resistance.
The starboard key switch is tuned off. Turn on the key.
Check and start the starboard engine.
Check if the starboard harness circuit breaker has tripped. Reset
the circuit breaker, if tripped.
Steering wheel does not steer the boat.
Reduce speed and change to joystick for directional control.
Check steering fluid level and fill if necessary. See
Section 5—
Maintenance
.
Contact your authorized Mercury MerCruiser dealer.
Steering works, but the boat is not as responsive.
Key off and key on.
Check and start the port engine.
Check the trim tab function.
Check the steering fluid level and fill if necessary. See
Section 5
— Maintenance
.
Contact your authorized Mercury MerCruiser dealer.
The steering wheel turned past end stop.
Key off and key on to restore steering wheel self‑centering, cruise
control, and to eliminate the fault code.
Power Trim Does Not Operate (Motor Does Not Operate)
Possible Cause Remedy
Blown fuse.
Replace fuse. Fuses may be located near the dash trim switch, at the trim pump, in the positive
(red) power trim battery lead near the battery switch, or a combination of these.
Loose or dirty electrical
connections or damaged
wiring.
Check all associated electrical connections and wires (especially battery cables). Clean and
tighten faulty connection. Repair or replace wiring.