Mercury KOB WL470, Руководство пользователя, Страница: 16 / 48

xDSL/ATU-R Connection
Connecting to Your ATU-R
If you are going to connect the WAN port to a ATU-R, follow the steps below:
HOW to setup:
1. Use the Ethernet cable comes with your ATU-R. Plug one end to the 10Base-T Ethernet
port of the modem, and the other end to the WAN port on your Broadband Wireless
Router (AP) (shown as Network 1 in the figure below).
2. Attach one end of the Ethernet cable with RJ-45 connector to the LAN port of your
Broadband Wireless Router (AP), and the other end to a hub or a client PC (shown as
Network 2 in the figure below).
3. At the LAN side, you also can use wireless client at the same time (please refer to “Basic
Configuration” section).
4. Set the ATU-R’s connection mode as bridge mode.
5. Enter the web-based Configuration Manager to configure the WAN setting. Choose the
connection type that you registered from your ISP (refer to “WAN Setting” section).
Note
To connect a configuration-purpose PC shown as Network 2 in the figure below,
please refer to “Basic Configuration”.
Network 1
Internet
ATU-R
Broadband Wireless Router (AP)
Ethernet LAN
Network 2
Wireless LAN
15