Mercury 92-858058K01, Руководство пользователя

Страница: 76 / 150

Section 3 - On the Water
Page 68 90-879172181
eng
FEBRUARY 2011
Manual-override buttons on front of manifold
a - Steer‑to‑starboard override button
b - Trim‑down override button
c - Hydraulic manifold
Manual-override buttons on rear of manifold
a - Hydraulic manifold
b - Trim‑up override button
c - Steer‑to‑port override button
!
WARNING
Accidental engine starting can cause serious injury or death. Remove the key from the ignition switch and engage the lanyard
stop or E‑stop switch to prevent the engine from starting when performing service or maintenance on the power package.
Procedure for a Stuck Steering Control Valve
1. Determine the drive that is not responding to steering control.
2. Shut down the engine and turn the key switch off. Wait at least 30 seconds, if possible.
3. Restart the engine. Confirm the steering fault has cleared.
4. If the steering fault did not clear, repeat the start/stop routine up to three times.
5. If the steering fault does not clear using the above procedure, then shift the transmission into neutral, shut down the engine,
turn the key switch off, and alternately push the port and starboard steering manual‑override buttons to release the spool.
Refer to the decal on the manifold bracket or on the port‑side of the drive cover, if equipped, for additional information.
6. Restart the engine. At the helm, steer the drive to the port and starboard to confirm the fault has cleared. If the Drive Steering
Response Fault, Drive Steering Control Fault, or Steering Spool Stuck fault remains, then shut down the engine and turn the
key switch off on the unresponsive drive. Operate on the remaining propulsion systems. Refer to
Loss of Engine
Operation
.
NOTE: Boat speed and maneuverability will be reduced.
Procedure for a Stuck Trim Tab Control Valve
1. Determine the drive that is not responding to trim control.
2. Shut down the engine and turn the key switch off. Wait at least 30 seconds, if possible.
3. Restart the engine. Confirm the trim tab fault has cleared.
4. If the trim tab fault did not clear, repeat the start/stop routine up to three times.
a
b
c
41307
b
c
a
41309