Mercury 92-858058K01, Руководство пользователя

Страница: 106 / 150

Section 5 - Maintenance
Page 98 90-879172181
eng
FEBRUARY 2011
Changing
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by law. Use caution not to spill oil, coolant,
or other fluids into the environment when using or servicing your boat. Be aware of the local restrictions governing the disposal
or recycling of waste, and contain and dispose of fluids as required.
!
WARNING
The rubber interface ring seal has an outside coating that protects the inner core. Tears, cuts, scrapes, or exposure to lubricants
or sealing compounds can damage this coating and the inner core causing water to leak into the boat. Use caution when installing
and working around the interface ring seal to prevent damage. Do not use any lubricants or sealing compounds during
installation.
1. Remove the drive cover, if equipped. Refer to
Removing the Drive Cover
.
2. Lay down oil‑absorbing wipes or material to catch excess transmission oil.
3. Remove the M30 drain plug and sealing washer from the aft, starboard end of the transmission and drain the transmission
oil (fluid) into a suitable container.
a - Transmission
b - Drain plug and sealing washer
4. On models with a drop box, remove the drain cap from the lower, port side of the drop box. Drain the transmission oil into a
suitable container.
a - Drop box
b - Drain cap
a
b
41194
a
b
41195