Mercury 8.2 H.O. ECT, Руководство пользователя, Страница: 62 / 94

Section 5 - Maintenance
Page 54 90-8M0061999
eng
MAY 2012
4. Install the dipstick, hand tighten the T‑handle to seat the O‑ring. Do not overtighten.
Typical ZF Marine Transmission
a - Dipstick
b - O‑ring
c - Dipstick hole
d - Full mark
e - Add mark
Checking While Engine is Cold
NOTE: Cold Fluid Level Check: To ease checking the fluid level, the dipstick can be marked or scribed with a cold level mark.
1. Follow the procedure for the warm fluid level check, then allow the boat to sit overnight.
IMPORTANT: Be sure to push the dipstick all the way down into the dipstick tube when checking the fluid level.
2. Remove the dipstick, wipe clean and reinsert.
3. Remove the dipstick, observe the fluid level and mark the cold fluid level.
4. Install the dipstick, hand tighten the T‑handle to seat the O‑ring. Do not overtighten.
Transmission Fluid
Model Capacity Fluid Type
63A 4.3 L (4.5 US qt)
Dexron III Automatic Transmission Fluid 63V 4.3 L (4.5 US qt)
80A 5.7 L (6 US qt)
Changing
Contact your authorized Mercury MerCruiser dealer.
Closed Cooling System
Coolant Requirement
NOTICE
Using propylene glycol antifreeze in the closed cooling system can damage the cooling system or the engine. Fill the closed
cooling system with an ethylene glycol antifreeze solution suitable to the lowest temperature to which the engine will be
exposed.
NOTE: All factory‑installed closed cooling systems come filled with Extended Life Coolant. This antifreeze requires draining and
replacing every five years or 1000 hours of operation, whichever comes first. The color of this antifreeze is orange. Any "top‑off"
fluid used must be Extended Life Coolant.
a
43702
b
c
e
d