Mercury 6.2 TowSport MPI, Руководство по эксплуатации и обслуживанию

Страница: 81 / 87

Section 8 - Checklists
90-8M0128975
eng
JUNE 2017 Page 73
Predelivery Inspection Checklist, Continued
N/A Check/
Adjust Item
On
‑
the
‑
Water Test
⃞ ⃞ Engine alignment (Inboard models only)
⃞ Starter neutral safety switch operation
⃞ E‑stop switch/lanyard stop switch operation (all helms)
⃞ Seawater pump operation
⃞ Operation of instruments
⃞ Fuel, oil, and water leaks
⃞ Exhaust leaks
⃞ Ignition timing
⃞ Forward, neutral, and reverse gear operation
⃞ Steering operation throughout range
⃞ Acceleration from idle RPM is normal
⃞ WOT________ RPM within specification (in forward gear)
⃞ ⃞ EC models: run two full operating cycles (key on/off) to WOT with engine at normal operating temperature
while monitoring engine with G3 CDS to verify engine goes into closed‑loop engine control.
⃞ ⃞ Power trim operation
⃞ ⃞ Boat handling
After On
‑
the
‑
Water Test
⃞ Propeller nut tightened to specification
⃞ Fuel, oil, coolant, water, and fluid leaks
⃞ Oil and fluid levels
⃞ Apply Quicksilver Corrosion Guard to engine package
⃞ Operation, Maintenance & Warranty manual in boat
If Boat Is Registered to a Resident of California
⃞ ⃞ CARB hang tag in boat
⃞ ⃞ CARB decal properly affixed to boat hull
Customer Delivery Inspection (CDI)
IMPORTANT: This checklist is for packages that are not equipped with joystick piloting. For engine packages equipped with
joystick piloting, use the checklist included with the joystick piloting operation manual.
Perform these tasks after the Predelivery Inspection (PDI).
This inspection must take place in the presence of the customer.
N/A Completed Item
⃞ Operation and Maintenance manual—provide and review with customer. Emphasize the importance of safety
warnings and Mercury engine testing procedures.
⃞ Approve the external appearance of the product (paint, cowl, decals, etc.)
⃞ Warranty—provide and explain the limited warranty to the customer. Explain dealer services.
⃞ ⃞ Explain the optional Mercury Product Protection Plan (North America only)
Operation of equipment—explain and demonstrate:
⃞ E‑stop switch/lanyard stop switch operation (all helms)
⃞ Cause and effect of steering torque or pull; instruct on using a firm steering grip; explain boat spin‑out and
how to trim for neutral steering
⃞ Explain the warning horn strategy—caution and critical
⃞ ⃞ U.S. Coast Guard capacity plate
⃞ Proper seating
⃞ Importance of personal flotation devices (PFDs or life vests) and throwable PFDs (throw cushions)
⃞ ⃞ Functions of SmartCraft accessories (if applicable)
⃞ Off‑season storage and maintenance schedule
⃞ Explain the power package flushing procedure
⃞ Engine (starting, stopping, shifting, using throttle)