Mercury 40 FourStroke Tiller Handle, Инструкция по эксплуатации, техническому обслуживанию, гарантии и установке, Страница: 67 / 107

EMISSION CERTIFICATION LABEL
An emission certification label, showing emission levels and engine
specifications directly related to emissions, is placed on the engine at time of
manufacture.
a - Idle speed
b - Engine horsepower
c - Piston displacement
d - Date of manufacture
e - Valve clearance (if applicable)
f - Family number
g - Maximum emission output for the engine family
h - Timing specification
i - Recommended spark plug and gap
OWNER RESPONSIBILITY
The owner/operator is required to have routine engine maintenance performed
to maintain emission levels within prescribed certification standards.
The owner/operator is not to modify the engine in any manner that would alter
the horsepower or allow emissions levels to exceed their predetermined factory
specifications.
Inspection and Maintenance Schedule
BEFORE EACH USE
• Check engine oil level. Refer to
Fuel and Oil
‑
Checking and Adding
Engine Oil
.
• Check that lanyard stop switch stops the engine.
• Visually inspect the fuel system for deterioration or leaks.
• Check outboard for tightness on transom.
• Check steering system for binding or loose components.
• Check propeller blades for damage.
SPARK PLUG:
GAP:
EMISSION CONTROL
INFORMATION
THIS ENGINE CONFORMS TO
EMISSION REGULATIONS FOR SPARK IGNITION MARINE ENGINES CALIFORNIA AND U.S. EPA
REFER TO OWNERS MANUAL FOR REQUIRED MAINTENANCE,
SPECIFICATIONS, AND ADJUSTMENTS
IDLE SPEED (in gear): FAMILY:
FEL:
TIMING (IN DEGREES):
COLD VALVE
CLEARANCE (mm)
INTAKE:
EXHAUST:
g/kWh
hp cc
21096
e
d
c
b
a
f
g
h
i
MAINTENANCE
eng
59