6 - M
AINTENANCE
90-8M0077672 JUNE 2013
43
1
2
3
4
5
6
7
8
9
3. If necessary, remove the fill cap and add fluid until the level in
the reservoir reaches the "MIN" level mark. It is acceptable to
fill the reservoir beyond the "MIN" level mark, but do not
overfill past the "MAX" level mark.
114
15033
Tube
Ref No.
Description
Where Used
Part No.
114
Power Trim
and Steering
Fluid
Trim pump reservoir
92-858074K01
4. Raise the sterndrive unit two or three times to bleed air out of
the system. The fluid level may drop. Add more fluid if
necessary, but do not overfill past the "MAX" level mark.
5. Replace the fill cap.
C
HECKING
T
RANSOM
I
NPUT
S
HAFT
B
EARING
H
OUSING
(D
RIVE
‑
LINE
M
ODELS
O
NLY
)
1. Remove the level indication (middle) pipe plug from the input
shaft housing. The gear lubricant level should be to the
bottom of the hole. If not, remove the pipe plug from the top of
the input shaft housing.
2. Fill the input shaft housing through the top pipe plug hole with
fluid until gear lubricant flows from the middle pipe plug hole
(do not overfill).
3. Install the pipe plugs into the input shaft housing and tighten
securely.
a -
Fill hole
b -
Check level here
c -
Drain
a
b
c
21730