MerCruiser Sterndrive TDI 3.0L, Руководство пользователя

Страница: 77 / 119

Section 5 - Maintenance
90-8M0070851
eng
AUGUST 2012 Page 69
6. Install the water‑in‑fuel sensor and tighten securely.
7. Connect the water‑in‑fuel harness connector.
8. Install the bleed screw and tighten securely.
9. Push on the primer pump on top of the fuel filter until increased resistance is felt. Increased resistance will indicate the fuel
system has been filled with fuel.
a - Primer pump
b - Bleed screw
c - Fine element fuel filter
d - Water‑in‑fuel sensor
e - Water‑in‑fuel sensor harness connector
Replacing
!
WARNING
Performing service or maintenance without first disconnecting the battery can cause product damage, personal injury, or
death due to fire, explosion, electrical shock, or unexpected engine starting. Always disconnect the battery cables from the
battery before maintaining, servicing, installing, or removing engine or drive components.
IMPORTANT: The fine element fuel filter cannot be cleaned and reused. It must be replaced.
1. Disconnect both battery cables from the battery.
2. Disconnect the water‑in‑fuel sensor harness connector.
3. Place a suitable container under the water separating fine element fuel filter.
4. Unscrew the fine element fuel filter and empty the fuel contents into the container.
5. Remove the water‑in‑fuel sensor and O‑ring from the fuel filter.
6. Install the water‑in‑fuel sensor with O‑ring into the new fuel filter. Tighten securely.
7. Fill the new fuel filter with clean diesel fuel.
NOTE: After replacing the fine element fuel filter and filling it with fuel, it is not necessary to bleed the fuel system.
8. Apply clean diesel fuel to the new fuel filter sealing O‑ring.
9. Install the new fine element fuel filter onto the filter bracket and tighten by hand.
10. Connect the water‑in‑fuel sensor harness connector.
11. After changing the fine element fuel filter, push on the primer pump on the filter housing until increased resistance is felt.
The fuel system has then been filled.
12. Visually check the fuel system for leaks.
13. Connect the battery cables.
14. Start and operate the engine. Check the filter connection for fuel leaks. If leaks exist, recheck filter installation. If leaks
continue, stop the engine immediately and contact your Mercury Diesel authorized repair facility.
Filling
A plunger‑type of primer pump is located on the fuel filter bracket and is used to:
•
Fill the fuel filter when draining or changing the fine element fuel filter.
• Fill the fuel system on the engine if the system was run dry.
• Prime the fuel system if the engine has not been run for an extended period.
NOTE: Follow this procedure after installing a new filter if it has not been prefilled or if the fuel has been drained from the filter
when checking for water.
1. Loosen the bleed screw on the fuel filter bracket.
2. Move the primer pump up and down repeatedly until the filter is full and the stream of fuel flowing from the bleed screw
contains no air bubbles.
a
50732
b
c
d
e