MerCruiser 3.0 TKS, Руководство пользователя

Страница: 89 / 112

Section 6 - Storage
90-8M0053372
eng
NOVEMBER 2010 Page 81
Engine and Fuel System Preparation
!
WARNING
Fuel is flammable and explosive. Ensure that the key switch is off and the lanyard is positioned so that the engine cannot
start. Do not smoke or allow sources of spark or open flame in the area while servicing. Keep the work area well ventilated
and avoid prolonged exposure to vapors. Always check for leaks before attempting to start the engine, and wipe up any
spilled fuel immediately.
!
WARNING
Fuel vapors trapped in the engine compartment may be an irritant, cause difficulty breathing, or may ignite resulting in a fire
or explosion. Always ventilate the engine compartment before servicing the power package.
1. Prepare carbureted fuel system for extended storage as follows:
a. Start engine.
b. Provide cooling water to the engine as done in the previous step.
c. Remove flame arrestor assembly.
d. Close the fuel shut off valve, if equipped. Disconnect and plug the fuel inlet fitting if not equipped with a fuel shut off
valve.
e. While operating engine at fast idle (1300 RPM), fog internal surfaces of induction system and combustion changers
by spraying approximately 227 g (8 oz.) of Mercury/Quicksilver Storage Seal or SAE 20W engine oil into carburetor
bores.
f. Spray the remaining 57 g (2 oz.) of Storage Seal (or oil) rapidly into carburetor, just as the engine begins to stall, due
to lack of fuel. Allow engine to stop.
Tube Ref No. Description Where Used Part No.
119
Storage Seal Rust
Inhibitor
Carburetor 92-858081K03
g. Turn ignition key to "OFF" position.
2. Refer to
Flushing the Power Package
and appropriately remove the water supply the the seawater pickup pump.
3. Clean the flame arrestor and crankcase ventilation hoses and reinstall.
4. Lubricate all items listed in the
Lubrication
section.
5. On models with closed cooling systems: Test coolant to ensure that it will withstand the lowest temperature expected
during storage.
6. Service batteries according to the manufacturer's instructions.
7. Clean the outside of the engine and repaint any areas required with Mercury/Quicksilver Light Gray Primer and Phantom
Black Paint. After paint has dried, wipe down the outside of the engine with Corrosion Guard.
Tube Ref No. Description Where Used Part No.
120
Corrosion Guard Outside of engine 92-802878 55
8. For sterndrive unit lay‑up, refer to appropriate Mercury MerCruiser sterndrive service manual.
9. Replace the fuel filter. Refer to the
Maintenance
section for proper procedure.
10. Change the oil and oil filter.
Draining the Seawater System
!
CAUTION
Water can enter the bilge when the drain system is open, damaging the engine or causing the boat to sink. Remove the boat
from the water or close the seacock, disconnect and plug the seawater inlet hose, and ensure the bilge pump is operational
before draining. Do not operate the engine with the drain system open.
IMPORTANT: Only drain the seawater section of the closed cooling system.
IMPORTANT: The boat must be as level as possible to ensure complete draining of the cooling system.
Your power package is equipped with a drain system. Refer to
Drain System Identification
to determine which instructions
apply to your power package.