MerCruiser 3.0 TKS, Руководство пользователя

Страница: 86 / 112

Section 5 - Maintenance
Page 78 90-8M0053372
eng
NOVEMBER 2010
Propshaft Anode (Bravo Three)
‑ Located behind the aft propeller.
a - Propshaft anode
In addition to the corrosion protection devices, the following steps should be taken to inhibit corrosion:
1. Paint your power package, refer to
Painting Your Power Package
.
2. Spray power package components on inside of boat annually with Corrosion Guard to protect finish from dulling and
corrosion. External power package components may also be sprayed.
3. All lubrication points, especially steering system, shift and throttle linkages, should be kept well lubricated.
4. Flush cooling system periodically, preferably after each use.
Painting Your Power Package
IMPORTANT: Corrosion damage that results from the improper application of anti‑fouling paint will not be covered by the
limited warranty.
1.
Painting Boat Hull or Boat Transom:
Anti‑fouling paint may be applied to boat hull and boat transom but you must
observe the following:
IMPORTANT: Do NOT paint anodes or MerCathode System reference electrode and anode, as this will render them
ineffective as galvanic corrosion inhibitors.
IMPORTANT: If anti‑fouling protection is required for boat hull or boat transom, copper or tin base paints, if not prohibited
by law, can be used. If using copper or tin based anti‑fouling paints, observe the following:
• Avoid any electrical interconnection between the Mercury MerCruiser Product, Anodic Blocks, or MerCathode System
and the paint by allowing a minimum of 40 mm (1‑1/2 in.) unpainted area on transom of the boat around these items.
a - Painted boat transom
b - Unpainted Area on Transom
2.
Painting Sterndrive Unit or Transom Assembly:
Sterndrive unit and transom assembly should be painted with a good
quality marine paint or an anti‑fouling paint that does not contain copper, tin, or any other material that could conduct
electrical current. Do not paint drain holes, anodes, MerCathode system, and items specified by boat manufacturer.
a
5821
b
a
5578