JUMPING CAR
14+
Printed in China
1-800-374-2744
FOR TECHNICAL SUPPORT,
PLEASE CALL
CONTENTS
1x Jumping Car
1x Remote Control
1x USB Charging Cable
1x 300mAh 3.7V Rechargeable Battery
RECHARGEABLE BATTERY WARNING
BATTERIES AND CHARGING
BATTERY WARNING
© 2019 MerchSource, LLC. Irvine, CA 92618. All rights reserved.
Due to continuous product improvements, the picture on the manual may differ
slightly from the actual product.
SAFETY PRECAUTIONS
• There is a risk of fire and personal injury if battery is punctured, damaged,
or misused
.
• Do not dismantle, crush, incinerate or short-circuit battery.
• Never expose battery to extreme temperatures or moisture.
• Keep away from flammable materials and direct sunlight.
•
Only charge using the provided charger, cable, and/or adapters.
•
Rechargeable battery is only to be charged by an adult.
• Adult Supervision of the battery while it is charging is required.
• Allow battery to cool to room temperature before charging.
• Charge on a non-flammable surface and keep away from flammable products.
• Discontinue charging if battery becomes hot, swells, smokes, or gives off a strong odor.
• Battery chargers used with the product are to be regularly examined for damage to
the cord, plug, enclosure, and other parts, and in the event of such damage, they
must not be used until the damage has been repaired.
• Remove batteries before storing.
• Recycle or dispose of battery according to federal, state, and local laws.
• Keep these instructions for future reference.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Alkaline batteries are recommended. Use only the specified voltage.
• Insert batteries using the correct polarity. Always use, replace, and recharge
(if applicable) batteries under adult supervision.
• Do not charge with non-rechargeable batteries.
• Do not short-circuit the battery supply terminals.
• Do not dispose of batteries in fire, batteries may explode or leak.
• Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state, and local laws.
• Keep these instructions for future reference.
The remote control requires 2 “AAA 1.5V alkaline batteries (not included).
REMOTE CONTROL:
• Use a Phillips head or Cross screwdriver to open the battery compartment at
the base of the remote.
• Insert the AAA 1.5V batteries according to the diagram inside the battery tray.
• Replace battery cover and tighten screw.
CAR:
• The charging port is located on the underside of the vehicle.
• ONLY use the included USB cable.
• Useable with standard 5V USB port or charger.
• Avoid water when operating.
• Do not submerge car or controller in water.
• Do not use people or animals as obstacles.
• Do not run car into furniture objects or hard surfaces as this will cause damage
to both the objects and car.
• Keep fingers, hair and loose clothing away from the tires, gears and motor while
car is switched to “ON’.
• Do not leave car or transmitter near sources of heat or under direct sunlight for
long periods of time.
• Remove all batteries when not in use to avoid accidental operation.
• Adult supervision is recommended when operating car.
• Thoroughly inspect products before every use. If the product appears worn,
frayed/splintered, cracked, or broken in any manner, discontinue use and discard
immediately.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
— Consult the dealer or an experienced radio/ TV technician for help.
WARNING: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION
FOR FUTURE REFERENCE.
300mAh
