Mercedes-Benz Zetros 2020, Руководство по эксплуатации

Страница: 69 / 212

Useful information
These Operating Instructions describe all the
models and standard and optional equipment
of your vehicle that were available at the time
of going to print. Country-specific differences
are possible. Bear in mind that your vehicle
may not be equipped with all the functions
described. This also applies to safety-relevant
systems and functions.
Read the information on qualified specialist
workshops (
Y
page 23).
Instrument cluster
Important safety notes
G
WARNING
If you are driving and reach through the
steering wheel to operate the adjustment
knob, you could lose control of the vehicle.
There is a risk of an accident and injury.
Only operate the adjustment knobs when
the vehicle is stationary. Do not reach
through the steering wheel when driving.
G
WARNING
If the instrument cluster has failed or mal-
functioned, you may not recognise function
restrictions relevant to safety. The operating
safety of your vehicle may be impaired.
There is a risk of an accident.
Drive on carefully. Have the vehicle checked
at a qualified specialist workshop immedi-
ately.
You should therefore make sure your vehicle is
operating safely at all times. Otherwise, you
could cause an accident by driving an unsafe
vehicle. If your vehicle is not operating safely,
stop immediately, paying attention to the road
and traffic conditions.
Rev counter
! If you exceed the maximum permissible
engine speed, the warning tone sounds.
You should not drive and change gear by the
sound of the engine, but according to the
engine speed shown in the rev counter.
Avoid driving in the red overrevving range.
This could lead to engine damage.
Example: instrument cluster
:
Economical speed range (green)
;
Engine brake operating range (yellow)
=
Overrevving range, danger of engine dam-
age (red)
If the
W
indicator lamp in the instrument
cluster lights up, the engine speed is high, e.g.
if you select a low gear when shifting down.
Observe further information in the event win-
dow of the on-board computer.
X Decelerate using the service brake.
or
X
Shift up a gear.
The
W
indicator lamp in the instrument
cluster goes out.
General notes on the rev counter:
R
Observe the rev counter while driving and
stay within economical speed range
:
.
In some situations, it may make sense to
operate the engine outside economical
engine speed range
:
, e.g. on uphill gradi-
ents or when overtaking.
R
If you drive the vehicle within economical
engine speed range
:
, you achieve low fuel
consumption and reduced wear.
R
In engine braking mode, use yellow engine
speed range
;
. The highest engine braking
effect will be achieved just before red over-
revving range
=
.
R
When driving downhill, make sure that the
engine speed does not rise into red overrev-
ving range
=
.
Instrument cluster
67
On-board computer and displays
Z