Information on the technical data
The given data only applies to vehicles with stand-
ard equipment. You can obtain further information
at a qualified specialist workshop.
Notes on work on the engine electronics
*
NOTES Premature wear through improper
maintenance
Improper maintenance may cause vehicle com-
ponents to wear more quickly and the vehicle's
operating permit may be invalidated.
#
Always have work on the engine elec-
tronics and related components carried
out at a qualified specialist workshop.
Installation notes for two-way radios
&
WARNING Risk of accident due to
improper work on two-way radios
If two-way radios are manipulated or retrofitted
incorrectly, the electromagnetic radiation from
the two-way radios can interfere with the vehi-
cle electronics and jeopardize the operating
safety of the vehicle.
#
You should have all work on electrical
and electronic components carried out
at a qualified specialist workshop.
&
WARNING Risk of accident due to
improper operation of two-way radios
If you use two-way radios in the vehicle
improperly, their electromagnetic radiation can
disrupt the vehicle's electronics. This is the
case in the following situations, in particular:
R
The two-way radio is not connected to an
exterior antenna.
R
The exterior antenna is installed incorrectly
or is not a low-reflection antenna.
This could jeopardize the operating safety of
the vehicle.
#
Have the low-reflection exterior antenna
installed at a qualified specialist work-
shop.
#
When operating two-way radios in the
vehicle, always connect them to the low-
reflection exterior antenna.
*
NOTE Invalidation of the operating permit
due to failure to comply with the instruc-
tions for installation and use
The operating permit may be invalidated if the
instructions for installation and use of two-way
radios are not observed.
#
Only use approved frequency bands.
#
Observe the maximum permissible out-
put power in these frequency bands.
#
Only use approved antenna positions.
Use Technical Specification ISO/TS 21609 (Road
Vehicles - EMC guidelines for installation of after-
market radio frequency transmitting equipment)
when retrofitting two-way radios. Comply with the
legal requirements for detachable parts.
If your vehicle has fittings for two-way radio equip-
ment, use the power supply or antenna connec-
tions intended for use with the fittings. Observe
the manufacturer's supplements during installa-
tion.
Mobile telephony transmission output
The maximum transmission outputs (PEAK) at the
base of the antenna must not exceed the values in
the following table:
Frequency band and maximum transmission out-
put
Frequency band
Maximum transmis-
sion output
Short wave
3 – 54 MHz
100 W
4‑m frequency band
74 – 88 MHz
30 W
2 ‑m‑ frequency band
144 – 174 MHz
50 W
Trunked radio system/
Tetra
380 – 460 MHz
10 W
270 Technical data
Содержание Sprinter
