Mercedes-Benz Sprinter, Руководство по эксплуатации

Страница: 234 / 354

Requirement
R
All electrical consumers are switched off.
Removing
#
Unscrew screws 3 and remove trim 2 .
#
Remove floor covering 1 .
Installing
#
Insert floor covering 1 and align with the driv-
er's seat base and the doorway.
#
Put trim
2
in place and screw screws 3
back in.
Disconnecting the starter battery
* NOTE Damage to electrical major assem-
bly due to disconnecting incorrectly
Electrical major assemblies could be damaged
if the starter battery is disconnected while the
vehicle is running.
#
Switch off the vehicle. Then, release the
battery clamps of the starter battery.
#
Always disconnect the starter battery in
the battery case in the left footwell first.
Otherwise, electrical major assemblies,
e.g. the alternator, could be damaged.
* NOTE Damage to the on-board electronics
due to disconnecting incorrectly
If the starter battery is not disconnected as
described below, the on-board electronics may
be damaged.
#
Always disconnect the starter battery as
described in the following sequence.
Never reverse the battery terminals. Oth-
erwise the on-board electronics may be
damaged.
%
If the vehicle is expected to be parked or out
of use for longer than four weeks, observe the
information on parking up the vehicle
(
/
page 142).
#
Vehicles with a battery main switch: remove
the main switch of the battery (
/
page 122).
#
Vehicles without a battery main switch: switch
off all electrical consumers.
#
Switch off the vehicle.
#
Remove the floor covering ( / page 231).
#
Remove screws 1 and slide battery cover 2
in the direction of the arrow.
The screws must protrude over the larger
recesses.
#
Remove battery cover
2
upwards.
232 Breakdown assistance