Mercedes-Benz smart Wallbox Home, Руководство по установке

Страница: 22 / 36

Setup mode.
Please follow these steps to change the maximum charging current setting of your smart Wallbox Home:
Working step Status of LED display
1. Switch off the power supply for the Wallbox via the upstream MCB and the
internal RCCB.
2. Remove the internal electronic components cover. Select the desired charge
current by setting the coded rotary switch to the respective position (see
table on the next page).
3. Replace the internal electronic components cover. Switch the RCCB to the
I
position. Replace and lock the housing cover.
4. Switch on the power supply for the Wallbox via the upstream MCB in the
domestic power distribution.
5. During start-up, the Wallbox will upload the setting of the coded rotary
switch and then work using the charging current set by the switch.
Settings for the coded rotary switch.
The following settings can be selected using the coded rotary switch:
Position Description Explanation
0 Normal operations Factory setting
1
Setting the maximum
charge current
8 A
2 10 A
3 13 A
4 16 A
5 20 A
6 20 A with 16 A imbalance detection
7 30 A
8 30 A with 16 A imbalance detection
9 30 A with 20 A imbalance detection
A 32 A
B 32 A with 16 A imbalance detection
C 32 A with 20 A imbalance detection
D no function -
E Test mode
Measuring voltage (contactor closed) and communications (CP)
possible at the charging contacts in order to test functionality
without a vehicle
F Normal operations Factory setting
PLEASE NOTE!
If you use the coded rotary switch to select a maximum charging current that is higher than the rated
current of the Wallbox, this manual setting will be ignored and the maximum rated curent will be used
instead.