Mercedes-Benz EQV 2021, Руководство пользователя

Страница: 220 / 300

The coolant level is correct in the following cases:
R
If the drive system is cold, up to marker bar 3
R
If the drive system is warm, up to 1.5 cm over
marker bar 3
Top up the coolant
Only use coolant approved for Mercedes-Benz to
avoid damaging the drive cooling system.
#
Refer to the information on coolant
(
/
page 250).
#
Refill the coolant up to the marker bar 3 in
the filler opening of the coolant expansion res-
ervoir 2 .
#
Replace cap 1 and tighten in a clockwise
direction.
#
Start the drive system.
#
Set the temperature in the vehicle interior to
the maximum output on the control panel of
the climate control.
#
After about five minutes, switch off the drive
system again and allow it to cool down.
#
Check the coolant level again and top up the
coolant if necessary.
Filling up the windscreen washer system
&
WARNING Risk of fire and injury from
windscreen washer concentrate
Windscreen washer concentrate is highly flam-
mable.
#
Avoid fire, naked flames, smoking and
the creation of sparks when using wind-
screen washer concentrate.
&
WARNING Risk of burns from hot compo-
nents in the engine compartment
Certain components in the engine compart-
ment can be very hot, e.g. the drive system
and the cooler.
#
Allow the drive system to cool down and
touch only the components described
below.
*
NOTE Damage to the exterior lighting due
to unsuitable windscreen washer fluid
Unsuitable windscreen washer fluids may dam-
age the plastic surface of the exterior lighting.
#
Only use windscreen washer fluids that
are also suitable for use on plastic surfa-
ces, e.g. MB SummerFit or MB WinterFit.
Topping up the washer fluid
Washer fluid reservoir (example)
#
Observe the notes on windscreen washer fluid
(
/
page 250).
#
Pull cap 1 upwards by the tab.
#
Top up the washer fluid.
#
Push cap 1 onto the filler opening until it
audibly engages.
Cleaning and care
Notes on washing the vehicle in an automatic car
wash
&
WARNING Risk of an accident due to
reduced braking power after washing the
vehicle
Braking efficiency is reduced after washing the
vehicle.
#
After the vehicle has been washed, brake
carefully while paying attention to the
traffic conditions until braking power has
been fully restored.
218 Maintenance and care
T447 0414 02