22
Electrohydraulic cab tilt system
Tilting t
he cab
Towing and Recovery | Actros, Antos (Model 963), Arocs (Model 964)
Tilting the cab forward
M
Observe the instructions before tilting the cab.
M
Press top of button
C
. The indicator lamp in
button
C
lights up. The cab tilt system is switched on.
Depending on the equipment installed, the cab can be tilted
forwards using the remote control under the maintenance
flap or with the button on the cab tilt pump.
Tilting the cab forwards with the remote control
M
Open maintenance flap.
M
Take out remote control
:
from holder and walk away
from the swivel range of the cab.
M
Press and hold the
Ç
button of the remote control
:
until the cab is tilted to the forward end position. When
the pump noise starts to get louder, the cab is at the
forward end position.
Tilting the cab back to the driving position with the
remote control
M
Press and hold the
Æ
button of the remote control
:
until the cab is tilted back to the rear end position and is
heard to lock. The cab locks automatically.
M
Place remote control in holder.
M
Close maintenance flap, see page 14.
M
In the cab, press bottom of button
C
. The indicator
lamp in button
C
goes out.
M
Check that the indicator lamp
º
in the instrument
cluster goes out after the engine starts.
M
If the indicator lamp
º
goes out, the cab is locked. If
the indicator lamp does not go out, repeat the procedure
and tilt the cab back again.
L cab (Actros)
