Mercedes-Benz Actros 2017, Руководство по эксплуатации

Страница: 422 / 436

The maximum oil change interval can only be
achieved by using engine oils of particularly high
quality in accordance with Sheet No. 228.51 of
the Mercedes-Benz Specifications for Service
Products. The on-board computer automatically
shows the date of the next oil change.
Adding or topping up the engine oil
! There is a risk of damage to the catalytic
converter or to the engine if too much oil is
added. Have excess oil drained off.
When topping up, Mercedes-Benz recommends
that you only use engine oil of the same grade
and SAE class as the oil filled at the last oil
change.
Check the oil level in the on-board computer
(
Y
page 148) before you top up the oil
(
Y
page 360).
Miscibility of engine oils
The benefits of high-quality engine oils are
diminished if you mix them.
Engine oils are differentiated according to:
R
engine oil brand
R
quality grade (Sheet No.)
R
SAE viscosity class
If, in exceptional circumstances, the type of
engine oil currently used is not available,
another engine oil approved for Mercedes-Benz
may be used.
Setting the oil grade
! If the on-board computer shows the
4
symbol and you top up with the quantity of oil
displayed in the on-board computer, note the
following:
R
If you top up with an engine oil of a lower
quality, set the lower quality (Sheet no.) in
the on-board computer.
R
If you top up with an engine oil of a higher
quality, do not set the higher quality (Sheet
no.) in the on-board computer.
X Set the Sheet No. (quality grade) of the engine
oil in the on-board computer (
Y
page 150).
Transmission oils
General notes
At the factory, drive axles, transmission and the
PTO shaft gear are filled with a high-quality syn-
thetic oil.
The planetary axles are filled with mineral oil.
Only use:
R
transmission oils which comply with Sheet
No. 236.91 for automatic transmissions
R
transmission oils which comply with Sheet
No. 235.11 for automated manual transmis-
sions
! When changing the oil, if you replace the
synthetic oil with a mineral transmission oil,
you may damage the assembly. Before the oil
change, check whether the use of a mineral
transmission oil is permitted. Information is
available from any Mercedes-Benz Service
Centre.
Transmission oil grade
The quality grade (Sheet No.) of the transmis-
sion oil used can be checked in the on-board
computer (
Y
page 151).
Coolant
G
WARNING
If antifreeze comes into contact with hot com-
ponents in the engine compartment, it may
ignite. There is a risk of fire and injury.
Let the engine cool down before you top up
the antifreeze. Make sure that antifreeze is
not spilled next to the filler neck. Thoroughly
clean the antifreeze from components before
starting the engine.
A coolant that ensures anti-corrosion/anti-
freeze protection and other important protec-
tive effects is added at the factory.
The coolant is a mixture of water and corrosion
inhibitor/antifreeze.
The corrosion inhibitor/antifreeze in the coolant
has the following properties:
R
heat transfer
R
anti-corrosion protection
420
Service products
Technical data