Setting the driving level
Example: STOP and driving level button
X
Using the button on the instrument panel:
press the
Ø
button.
The chassis is raised or lowered automatically
to the driving level. When the chassis is at
driving level, the
¸
indicator lamp in the
instrument cluster goes out.
X
Press the
¤
button to interrupt/cancel the
raising or lowering operation.
X
Using the control panel: press the
u
or
t
button to select driving level preselec-
tion
=
.
The LEDs for driving level preselection
=
light up.
X
Briefly press the
r
or
s
button.
The chassis is raised or lowered automatically
to the driving level. When the chassis is at
driving level, the
¸
indicator lamp in the
instrument cluster goes out.
X
Press the
T
button to interrupt/cancel the
raising or lowering operation.
Loading and unloading the vehicle
when the ignition is switched off
!
Before removing the demountable body,
lower the chassis frame completely. Other-
wise, the chassis frame could spring up sud-
denly when the special-purpose body is
removed. This could damage the shock
absorbers.
Store a constant chassis height for loading and
unloading the vehicle.
X
Vehicles with a trailing axle: lower the trailing
X
If required, raise/lower the chassis to the
desired height.
X
Run the engine until the pressure regulator
cuts out.
X
Press and hold the
T
button on the control
panel or the
¤
button on the instrument
panel.
X
Switch off the engine.
X
Remove the key from the key slot.
X
Release the
T
button on the control panel or
the
¤
button on the instrument panel.
If there is sufficient reservoir pressure in the
compressed-air system, the height of the
chassis frame is kept constant for approx-
imately 4 to 5 hours.
Forced lowering without residual air
bellow pressure regulation
Forced lowering
If you engage power take-off, the vehicle is com-
pletely lowered on all air-sprung axles. This
increases the vehicle's tilt stability. If you dis-
engage power take-off, the vehicle remains low-
ered until you select a level.
Forced lowering is ended if:
R
you switch the ignition off and on again
R
you press the
T
button on the control unit
R
you press the
¤
button on the instrument
panel
R
you press the
ë
button
Road paver mode
Example: road paver mode button
In road paver mode, the level control perma-
nently regulates the driving level, regardless of
operating conditions. This enables the level rel-
ative to the road paver to be maintained and
forced lowering is deactivated.
298
Level control
Driving mode
Содержание Actros 2017
