Mercedes-Benz Actros 2017, Руководство по эксплуатации

Страница: 299 / 436

Raising or lowering the chassis with
the control panel
G
WARNING
People's limbs may become trapped if they
are located underneath the vehicle or
between the vehicle body and the tyres when
the vehicle is lowering. There is a danger of
injury.
When lowering the vehicle, make sure no one
is underneath the vehicle or in the immediate
vicinity of the wheel arches.
X
Press the
u
or
t
button to select front
axle
:
, entire vehicle
;
or rear axle
?
.
The LEDs for the selected preselection light
up.
X
Press the
r
button to lower the chassis or
the
s
button to raise it.
If the chassis is not at driving level, the
¸
indicator lamp in the instrument cluster lights
up. Additionally, a yellow event window
appears in the on-board computer with
=
or
?
and
Set driving level
.
X
Press the
T
button to interrupt/cancel the
raising or lowering operation.
Raising or lowering the chassis with
the button on the instrument panel
G
WARNING
People's limbs may become trapped if they
are located underneath the vehicle or
between the vehicle body and the tyres when
the vehicle is lowering. There is a danger of
injury.
When lowering the vehicle, make sure no one
is underneath the vehicle or in the immediate
vicinity of the wheel arches.
X
To raise: press the upper section of the ¥
button.
The chassis is raised as long as you press the
button.
X To lower: press the lower section of the ¦
button.
The chassis is lowered for as long as you press
the button.
If the chassis is not at driving level, the
¸
indicator lamp in the instrument cluster lights
up.
A yellow event window appears in the on-board
computer with
=
or
?
and
Set driving
level .
Storing or calling up the chassis
height
X To store: raise/lower the chassis to the
desired height.
X
Press the
û
button for approximately
2 seconds for memory position M1 or M2.
The current chassis frame height is stored
under the corresponding
û
button.
X
To call up: briefly press the
û
button for
memory position M1 or M2.
The chassis will be raised/lowered automat-
ically to the stored height.
A yellow event window appears in the on-
board computer with
=
or
?
and Set
driving level
.
X Press the
T
button to interrupt/cancel the
raising or lowering operation.
Level control
297
Driving mode
Z