Mercedes-Benz 2013 CLS Coupe, Руководство пользователя

Страница: 412 / 424

Assuring the purity of AdBlue
®
is particularly
important with respect to avoiding malfunc-
tions in the BlueTEC exhaust gas aftertreat-
ment system.
If AdBlue
®
is pumped out of the AdBlue
®
tank,
e.g. during repair work, do not use this fluid
to refill the tank. The purity of the fluid can no
longer be guaranteed.
Capacities
Model Total capacity
CLS 350 BlueTEC
CLS 350 BlueTEC
4MATIC
24.5 l
Engine oil
General notes
Comply with the important safety notes for
service products when handling engine oil
(
Y
page 405).
The quality of the engine oil is decisive for the
function and service life of an engine. After
extensive tests, Mercedes-Benz approves
engine oils that correspond to the current
technical standard.
Therefore, only Mercedes-Benz approved
engine oils may be used in Mercedes-Benz
engines.
Further information on tested and approved
engine oils can be obtained from any
Mercedes-Benz Service Centre. Mercedes-
Benz recommends that you have the oil
change carried out at a qualified specialist
workshop. Mercedes-Benz approval is indica-
ted on the oil container by the inscription "MB
Approval" and the corresponding designa-
tion, e.g. MB Approval 229.51.
You can call up an overview of approved
engine oils on the Internet at:
http://bevo.mercedes-benz.com by enter-
ing the designation, e.g. 229.5.
The table shows which engine oils have been
approved for your vehicle.
Petrol engines MB Approval
CLS 350
229.3, 229.5
CLS 500
CLS 500 4MATIC
CLS 63 AMG
CLS 63 AMG 4MATIC
229.5
Diesel engines with
diesel particle filter
MB Approval
All models 228.51,
229.31, 229.51
Use only SAE 0W-40 or SAE 5W-40 engine oils
for AMG vehicles.
i
If the engine oils listed in the table are not
available, you may add the following engine
oils until the next oil change:
R
vehicles with a petrol engine: MB
Approval 229.1, 229.3 or ACEA A3
R
diesel engines: MB Approval 229.1,
229.3, 229.5 or ACEA C3
Use only SAE 0W-40 or SAE 5W-40 engine
oils for AMG vehicles.
This must only be added once and the
amount must not be greater than 1.0 l.
Capacities
The following values refer to an oil change
including the oil filter.
410
Service products and capacities
Technical data