Mercedes-Benz 2013 CLA, Руководство пользователя

Страница: 120 / 352

X
To open: loosen side trim panel
:
at the
top and fold it down in the direction of the
arrow.
X
To close: insert side panel
:
.
Tail lamps
X
Switch off the lights.
X
Open the boot.
X
Open the side trim panel (
Y
page 117).
X
Release and remove connector.
X Press retaining clips
:
at the same time in
the direction of the arrows.
X
Pull the bulb holder out with the bulbs.
Bulb holder
:
Brake lamp
;
Brake lamp
=
Rear foglamp
?
Reversing lamp
A
Turn signals
X
Brake lamp/rear foglamp/reversing
lamp: remove the corresponding bulb from
the bulb holder.
X Insert the new bulb into the bulb holder.
X
Turn signal lamp: lightly press the bulb
into the bulb holder, turn it anti-clockwise
and remove it from the bulb holder.
X
Insert the new bulb into the bulb holder and
turn it clockwise.
X
Reinsert the bulb holder and engage on
retaining clips
:
.
X
Re-establish contact with the connector.
X
Close the side trim panel (
Y
page 117).
Windscreen wipers
Switching the windscreen wipers on/
off
!
Do not operate the windscreen wipers
when the windscreen is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windscreen can
scratch the glass if wiping takes place when
the windscreen is dry.
If it is necessary to switch on the wind-
screen wipers in dry weather conditions,
always operate them using washer fluid.
! If the windscreen wipers leave smears on
the windscreen after the vehicle has been
washed in an automatic car wash, this may
be due to wax or other residue. Clean the
windscreen with washer fluid after an auto-
matic car wash.
118
Windscreen wipers
Lights and windscreen wipers