Mercedes-Benz 2011 C 250, Руководство оператора

Страница: 111 / 320

The
K
indicator lamp in the instrument
cluster lights up when the high-beam
headlamps are switched on.
X
To switch off the high-beam
headlamps: move the combination switch
back to its normal position.
The
K
indicator lamp in the instrument
cluster goes out.
High-beam flasher
X
To switch on: turn the key in the ignition
lock to position 1 or 2 or start the engine.
X
Pull the combination switch briefly in the
direction of arrow
=
.
Hazard warning lamps
The hazard warning lamps automatically
switch on:
R
if an air bag is deployed
R
the vehicle decelerates rapidly from a
speed of more than 45 mph (70 km/h) and
comes to a standstill.
X
To switch on the hazard warning lamps:
press button
:
.
All turn signals flash. If you now switch on
a turn signal using the combination switch,
only the turn signal lamp on the
corresponding side of the vehicle will flash.
X
To switch off the hazard warning
lamps: press button
:
.
The hazard warning lamp switches off
automatically after full brake application if the
vehicle then reaches a speed above
6 mph (10 km/h) again.
i The hazard warning lamps still operate if
the ignition is switched off.
Headlamp cleaning system
The headlamps are cleaned automatically if
the "Wipe with washer fluid" function is
operated ten times while the lights are on and
the engine is running (
Y
page 116). When you
switch off the ignition, the automatic
headlamp cleaning system is reset and
counting is resumed from 0.
Active light function
The active light function is a system that
moves the headlamps according to the
steering movements of the front wheels. In
this way, relevant areas remain illuminated
while driving. This allows you to recognize
pedestrians, cyclists and animals.
Active: when the lights are switched on.
Exterior lighting
109
Lights and windshield wipers
BA 204 USA, CA Edition A 2011; 1; 5, en-US
hereepe
Version: 3.0.3.6
2010-05-20T09:17:30+02:00 - Seite 109
Z