HARDWARE: CIG005A3
SOFTWARE: 1.0.3 o POSTERIOR
GV.1.3.5
Compact
emergency
phone
MMk-656
(OPTIONAL)
RS-232*
RS-485*
CAN BUS 1*
CAN BUS 2*
GPOS
FXS (connection to phone)
Power supply
OFF/ON Switch
Antenna
Status indicator
Battery indicator
Coverage indicator
Autoconfiguration button
*Aviable depending on model
1
2A
2B
3
4
5
6
7
8
9
10
11
12
Power supply
MMk-108
for GSM/M2M
Gateway
(SUPPLIED)
5
4
3
2
1
7
6
8
9
+
-
OFF/ON
6,2 mm
Negativo -
Po
1,9 mm
TIP
RING
AUX OUT 12Vdc
AUX OUT Colector NPN
OMLS 12Vdc
OMSL Colector NPN - Out Mobile Signal
CAN2 H
CAN2 L
CAN2_GND
CAN1 H
CAN1 L
CAN1_GND
RS485 B
RS485 A
RS485_GND
Modelo 736F
TX
CTS
RX
RTS
GND
RS232C Pines
SMA Antena
Tarjeta SIM
CAR
MACHINE
ROOM
GSM/M2M GATEWAY MMk-736F / MMk-736N
QUICK SETUP GUIDE
PREPARING THE SIM CARD
1)
For the following settings, previously introduce the SIM card in a free mobile phone or a mobile telephone
phone from the SIM card provider.
2)
Check that the PIN access code of the SIM card is disabled through the security configuration.
3)
Disable all call forwarding and voicemail line: type
##002#
, after a few seconds, the operator will confirm
the cancellation with a message on the screen.
INSTALLATION AND STARTUP
1)
Introduce the SIM and connect the supplied external antenna to the device
2)
Connect the emergency phone to the port FXS.
3)
For remote monitoring (Model MMk-736F), connect the lift controller to the corresponding
4)
Connect the power supply to the supplied power adapter (12VDC IN).
5)
Turn on the device (OFF/ON).
WARNING:
MERak recommends using the supplied antenna and power adapter. Using an unapproved
by MERak antennas or power adapters may affect the correct performance of the device.
Is important to look for a location for the antenna that provides the best level of coverage: this ensures
the maximum audio quality while performing voice calls.
To guarantee that enought charge is available to make an emergency call in power failure situations,
the battery must be completely charged in it’s first use.
Standard telephone landline generator and remote monitoring for lifts
communications port (RS232, RS485, CAN1, CAN2).
WIRING
