User Manual FSK700-2 / FSK700-2SX
Chapter 5 • Commissioning
29
5.3.3
Automatic deactivation of the release magnet when outer door is open
The electromagnetic unlocking device of the outer door is designed for a duty cycle of 100%. Dur-
ing emergency operation, the release magnet is activated, and will only be deactivated again once
normal condition is restored (at factory default settings).
To conserve energy (drawn from the emergency battery during a power blackout) during emer-
gency operation, it is possible to automatically deactivate the release magnet upon opening the
outer door. When the outer door is closed hereafter, – provided fire alarm is still active – the release
magnet will be reactivated, and the door can be opened again. To enable this energy conservation
function, Jumper JP2 must be connected to both pins (the jumper is connected only to one pin at
factory default settings) on Connection Board APL-4 (see Fig. 13 on page 21).
5.4
Commissioning instructions
The following instructions for commissioning require that, before starting,
the locking bolt has not been installed yet,
all locking cylinders, as well as the inner door have been installed, and the corresponding keys
are readily available. Should this not be possible at the time of commissioning, fitting substitute
locking cylinders or locks that will be replaced at a later time must be utilised instead.
Key Safe FSK700-2, or FSK700-2SX, respectively, has been connected to a VdS-certified con-
trolling and monitoring device,
If the Key Safe is connected not to the Key Safe Controlling and Monitoring Device AD900-1 by
MEP, but to a controlling and monitoring device by another manufacturer, some of its functional-
ity can differ from the way described herein.
the Flush Mounting Frame with Drill Protection has been connected (if applicable),
the Tamper Switch of the Key Safe Column has been connected, and the top cover has been
properly installed (if applicable),
ample supply voltage for operation of the Key Safe is available and has been properly connec-
ted.
The controlling and monitoring device must not necessarily be connected to a fire detection con-
trol panel or a burglar alarm control panel during commissioning. However, a suitable power
supply must be available.
During commissioning, the steps listed below must be followed in order!
1
Checking the functioning of the closure device
With the outer door open and without locking bolt, verify the proper functioning of the clos-
ure device by repeatedly activating it using the controlling and monitoring device. The lock-
ing angle must thereby move upwards.
If Jumper JP2 is connected to both pins on Connection Board APL-4, the closure device is
only activated while the outer door is closed. In this case, the closed state must be simulated
by triggering the outer door closing contact.
Should any problems that limit the proper functioning of the closure device arise, it is imper-
ative that these problems are resolved before the installation of the locking bolt!
2
Installing the locking bolt in the outer door
Fig. 21:
Inserting the locking bolt along with the steel ball in the outer door
HB_FSK700_1020_9161690_Englisch_D.odt / 1022 D / AN9161690
ZN62163/38/29
29
Содержание Fire Brigade Key FSK700 Series
Страница 2: ......
