Mendota SEABROOK D-40, Инструкция по установке и эксплуатации

Страница: 19 / 44

18
LIGHTING INSTRUCTIONS
IMPORTANT: Be sure all items on "LIGHTING CHECK OFF LIST" [Pg. 17] have been completed!
CAUTION: If the pilot goes out, be sure to wait a minimum of five minutes before relighting -
BE SURE TO
ALWAYS REMOVE THE GLASS BEFORE RELIGHTING THE PILOT.
1. Remove glass door - ALWAYS LIGHT PILOT WITH GLASS REMOVED
!
2. Make sure any gas supply shut-off cocks are open and Thermostat is
"OFF".
3. Push in Gas Cock Dial Slightly and turn clockwise to "OFF". NOTE: Dial
cannot be turned from "PILOT" to "OFF" unless dial is pushed slightly. DO
NOT FORCE!
4. Wait five (5) minutes to allow gas which may have accumulated in main
burner compartment to escape. If you smell gas, STOP.
5. Turn Gas Cock Dial Counterclockwise to "PILOT" position.
6. Depress Gas Cock Dial and push in red Piezo igniter button. Once pilot
ignites, continue depressing dial for about ½ minute. If pilot does not remain
ignited, repeat operation allowing a longer period before releasing Gas Cock
Dial.
7. Push Rear Flame ON/OFF switch to “on”. This switch is located behind lower grill on left side. See below.
he 9 Volt Battery required for the Rear Flame ON/OFF function is mounted on the back-side of the Control
Panel shown in the diagram above. To access this battery, remove the control panel mounting screws and flip
this panel downward. Replace the battery with a high quality 9V Battery only.
8. After pilot is lit and before installing logs, turn Gas Dial to "ON" and "cycle" the burner on/off to make
certain it ignites promptly and that the flame runs smoothly around burner curve and promptly lights entire
burner.
9. With pilot operating, install log set and coals (see PG. 20). With logs/coals in place, "cycle" the burner again
to make sure of prompt ignition of burner and that the flame runs smoothly around entire burner. NOTE :
Logs will produce a strong, acrid odor on initial contact with flames.
10. Reinstall glass front by "hanging" slots on upper edge of door over tabs on upper edge of firebox opening.
Then "swing in" lower edge of door. Carefully pull out the two (2) Spring Loaded Door Holding Bars located
under the doorframe. Raise Bars and fit Bars firmly into Bar Holding Brackets on doorframe (see instructions
PG. 10).
11. NOTE: Be sure doorframe is "centered" in firebox opening. To "center": Release Door Holding Bars, with
door "hanging" in upper slots "slide" door frame (within the slots) to center of firebox. Replace Door Holding
Bars.
12. Turn Gas Dial counterclockwise to "ON" then set Thermostat or push Remote Control to turn on burner.
FIGURE 11: Gas Valve
IMPORTANT: After pilot is lit, system millivolt readings and gas pressure should be taken by qualified installer.
Pilot flame must register a minimum of 325 millivolts.
f i r e - p a r t s . c o m