Memotec NetPerformer SDM-9120 Series, Руководство по установке оборудования

Страница: 64 / 161

NetPerformer Hardware Installation Guide
3-36 Memotec Inc.
3.10.2 Important Console and Modem Settings for Startup
The console port performs autobaud detection when in auto-sensing mode. The SDM-
9XXX Series unit will set the speed of the console port as soon as it detects an active
connection.
• Console terminal:
The default console speed is 9600 bps during bootstrap
initialization, boot sector validation and system initialization.
Set your console
terminal emulator to 9600 bps
to view all the system status messages of the
SDM-9XXX Series unit on-screen during the startup sequence.
• Modem:
Configure your modem with the following
AT
commands:
-
at&d0
to ignore DTR. The SDM-9XXX Series unit cannot supply DTR to the
modem when in auto-sensing mode (the default setting).
-
ats0=1
for Auto Answer mode.
-
at&w0
to save the modem configuration.
Once system startup has completed successfully, the SDM-9XXX Series unit enters auto-
sensing mode automatically. At that point, you can change your console speed, if desired.
•
Available console speeds are 1200, 2400, 4800, 9600, 19200, 28800, 38400,
57600 and 115200 bps.
The equipment you connect to the console port must
operate at one of these speeds.
Caution
For a trouble-free startup, you must set the console terminal and
modem as follows: